HE_6100-6200-INS-LAB-RevC22
2
CHAIR ASSEMBLY
Tools required: Phillips screwdriver
Attaching Back to Frame
1. Place the flat side of the back in position against the rail at rear of frame with curve upward, as shown
at above left, centering the back evenly against the chair frame. Use provided wood screws to secure
with back frame.
2. Secure the back to the frame, as shown above. Use a Phillips screwdriver and the provided four
screws and washers, two screws and washers per side as shown, until tight.
Arm Height and Position Adjustment
1. Pull the plunger-knob, located on front of arm receiver tube, out to release the arm.
2. Slide the arm to the desired height and position.
3. Release the plunger-knob to lock the arm at desired height and position.
WARNING: Ensure arms are locked securely in place before proceeding.
OPERATION
WARNING: Ensure the Blood-Draw / Phlebotomy Chair is securely assembled as previously
described before each use. Monitor patient to ensure Blood-Draw / Phlebotomy Chair does
not adversely affect patient in any way. If so, discontinue use immediately.
CARE AND MAINTENANCE
Cleaning and Disinfection
WARNING: Check the Blood-Draw / Phlebotomy Chair before each use for signs of
damage. If damage is found, DO NOT use the Blood-Draw / Phlebotomy Chair. Contact GF
immediately.
To clean Blood-Draw / Phlebotomy Chair, hand wash gently with warm water and a mild soap or
detergent, rinse with clear water, and air dry.
To disinfect Blood-Draw / Phlebotomy Chair, use a diluted solution of 10% (or less) household bleach
containing 5.25% sodium hypochlorite, rinse with clear water, and air dry.
NOTICE: DO NOT use abrasive cleaners or scouring pads on any part of the Blood-Draw /
Phlebotomy Chair.
WARNING: Inspect all components periodically and replace as needed.
Every three months
• Check back to ensure screws are tight; if not, tighten.
