gmb / BA PowerGear_EN as of May 2015 / 29.10.2015
Page 20 of 23
Caution
:
There is a
risk of burns
on the hot gear unit,
and a
risk of scalding
when draining the oil!
Provide for suitable protection measures!
Screw off aeration and ventilation filter or remove top screw plug on one side of the housing, open oil drain plug
and catch oil in suitable vessel.
Fit drain plug with new copper seal and screw back into housing.
Fill gear unit with oil, see also Chapter 8.
Replace oil filler plug or aeration and ventilation filter.
Material damage
Possible damage to the gear unit by defective lubrication due to incorrect or mixed
oils.
When carrying out an oil change always refill with the oil type previously used!
It is not permitted to mix different makes or mineral and synthetic oils, in particular
hydrocarbon oils must not be mixed with polyglycols. The mixtures may become
resinous or agglutinate and then precipitate into the gear unit.
11.5 Checking gear unit condition
This check must only be carried out by qualified operating personnel or the MS-Graessner service department.
Here it must be possible to assess reliably what exactly needs to be replaced on the gear unit, or it must be de-
termined that all gear unit components are in order.
12. Replacement parts, replacement part stocks, service
12.1 Replacement parts
Wear part packs and replacement parts complete with replacement or repair instructions are available from our
service department
.
The designation and positioning of the individual parts are shown in the associated dimension sheets and re-
placement part drawings.
12.2 Replacement part stocks
We recommend keeping a stock of the most important replacement parts and wear parts in the vicinity of the
place of use of the gear unit, so as to ensure the operational readiness of the gear unit in this way.
The parts are shown in the replacement part drawings
12.3 Service
Should you require
help from our service department
please provide the following details:
- Gear unit type and size
- All data printed on the type plate (see photograph on page 7).
If the type plate is missing, you will find the serial number stamped into the housing.
- Type and scope of the fault
- Suspected cause
- Photographs of any damage (digital)
Note
Contact to Customer Service see pages 4, 8 and 20 (bottom)
