10
Warning!
Make sure the concrete wall is solid and at least 8 inches (20 cm) thick. If
the concrete exhibits cracks or other defects, this may result in failure of the concrete
anchors and cause serious personal injury and damage your display.
1.
Place the wall bracket up to the location marked for your display, and use a pencil to mark three drilling holes for the concrete anchors.
Use the included bubble level to make sure the bracket is level before drilling.
2.
Use a 10 mm concrete drill bit to predrill the holes 2.4 inches (60 mm) deep, and then clean out the debris from the holes.
3.
Insert the concrete anchors, and use a hammer to tap the anchors into the concrete.
4.
Attach the bracket to the wall by inserting the anchor screws through the washers and the wall bracket's mounting holes and screw them into the
anchors until secure. Use the wrench to further tighten the anchor screws, but do not overtighten. Use the included bubble level to make sure the
bracket is level.
Attaching the Wall Bracket to Concrete
2.4 in.
2.4 in.
Important!
We recommend that two people perform this step.
Lift your display up to the wall bracket, and hang it from the top hooks of the display's brackets until the latchs
click secure.
Important!
We recommend that two people perform this step.
To remove the display from the wall bracket,
pull down on both drawstrings, and swing the
display outward, and away from the wall.
Q
1X
A
N
3X
P
3X
O
3X
2
4
Wall brackets mounted
to concrete, with
correct screw placement
1/8-inch (3 mm)
