Graco VPM 12, Instructions Manual

Page: 4 / 88

Models
4 313875J
Models
* Full load amps with all devices operating at maximum capabilities. Fuse requirements at various flow rates and
mix chamber sizes may be less.
** Values are dependent on installed pump size. Values shown are for largest available pump size.
◆
Flow rate is independent of frequency 50/60 Hz.
❖
Flow rate increases with flow meters removed.
‡ The maximum fluid working pressure for the base machine without hoses is 3000 psi (21 MPa, 207 bar). If hoses
rated at less than 3000 psi are installed, the system maximum fluid working pressure becomes the rating of the
hoses. If 2000 psi hoses were purchased and installed by Graco, the working pressure for the machine is already
setup for the lower 2000 psi (14 MPa, 138 bar) working pressure by Graco. If the machine was purchased without
hoses and aftermarket hoses rated at or above 3000 psi are to be installed, see
Adjust Motor Control Module
Selector Switch on page 27 for the procedure to setup the machine for higher rated hoses. The change in work-
ing pressure is made by changing a rotary switch setting in the Motor Control Module. The minimum pressure rat-
ing for hoses is 2000 psi. Do not install hoses with a pressure rating lower than 2000 psi.
Accessories
Heated Platen Kits
The Heated Platen kits convert the standard platen to a
heated platen to enable dispensing in lower temperature
environments.
Power Distribution Box Conversion Kits
These conversion kits convert the voltage and CE
approval of a system.
System Description
Full Load Peak Amps
Per Phase*
Voltage
(phase) System
Watts
Max Flow
Rate
◆
**
lb/min
(kg/min)
Approximat
e Output
per Cycle
(A+B)**
gal. (liter)
Hydraulic
Pressure
Ratio**
Maximum
Fluid
Working
Pressure ‡
psi (MPa,
bar)
No
Heat
1
Heated
Platen
2
Heated
Platen
24F226
VPM-25,
Boom
mounted
dispense
valve
55 A 62 A 62 A 400 (3)
24,000
(No Heat)
27,600
(1 Platen)
31,200
(2 Platens)
55 (25)
0.2 (0.76) 1.87
3000
(21, 207)
24F874 60 A 76 A 86 A 230 (3)
24F875
✔
55 A 62 A 62 A 400 (3)
24J509
VPM-12,
Mast
mounted
dispense
valve,
reduced
flow
55 A 62 A 62 A 400 (3)
26 (12)
24J510 60 A 76 A 86 A 230 (3)
24J511
✔
55 A 62 A 62 A 400 (3)
Part Description
24E267 B (Blue) Side Kit
24E268
A (Red) Side Kit
Part Description
24E269
400V Non-CE Conversion Kit
24E272
400V CE Conversion Kit