Graco T-MAX 506, Operation - Repair - Parts

Page: 16 / 88

Preparation
16 3A6748B
Preparation
Grounding
This product is equipped with a cord having
a grounding wire with an appropriate
grounding plug. The plug must be plugged
into an outlet that is properly installed and
grounded in accordance with all local codes
and ordinances.
Do not modify the plug provided; if it does not
fit the outlet, have the proper outlet installed
by a qualified electrician.
Solvent-Based Materials
NOTE: All hoses sent with the unit are for
water-based material application only.
Solvent compatible hoses and applicators
must be used.
Flush the Equipment
•
Flush before changing materials, before
fluid can dry or cure in the equipment, at
the end of the day, before storing, and
before repairing equipment.
•
Flush with a fluid that is compatible with
the fluid being dispensed and the
equipment wetted parts.
•
Flush at the lowest pressure possible.
Check connectors for leaks and tighten
as necessary.
1. Follow Pressure Relief Procedure ,
page 19.
2. Set pump to lowest possible fluid
pressure, and start pump.
3. Hold a metal part of the gun firmly to a
grounded metal pail. Trigger the gun
until clean solvent dispenses.
Amp Switch
Select 15A or 20A depending on your circuit
rating. 110V units require 100-120 VAC,
50/60 Hz, 15 – 20A, 1 phase
Select 10A or 16A depending on your circuit
rating. 230V units require 220-240 VAC,
50/60 Hz, 10 – 16A, 1 phase
The equipment must be grounded to
reduce the risk of static sparking and
electric shock. An electric or static spark
can cause fumes to ignite or explode. An
improper ground can cause electric shock.
A good ground provides an escape wire for
the electric current.
To avoid fire and explosion, always
ground equipment and waste container.
To avoid static sparking and injury from
splashing, always flush at the lowest
possible pressure.