Graco SoloTech ST10, Repair And Parts Manual

Page: 18 / 36

Repair
Install Install Install the the the Front Front Front Cover Cover Cover
1. Clean any debris from the gasket mating surfaces
on the front cover (16) and the pump housing (1).
NOTE: NOTE: NOTE: The pump housing and front cover must
be free of dirt, debris and residue to ensure a
leak-free seal.
2. Line up the holes in the gasket (15) with the holes
in the cover (16). Place the gasket on the cover.
3. Line up the front cover (16) and gasket (15)
with the pump housing (1).
ST6 ST6 ST6 ,,, ST10 ST10 ST10 ,,, ST23 ST23 ST23 ,,,
and and
and
ST25FG ST25FG
ST25FG
::: Install the flangehead bolts (45)
onto the front cover (16). ST26 ST26 ST26 ,,, ST30 ST30 ST30 ,,, and and and
ST32 ST32 ST32 ::: Install the bolts (45), with flat washers
(53) and lock washers (52), onto the front cover
(16).Torque the bolts evenly and oppositely to
the torque shown in the table.
Model Model
Model
Torque Torque
Torque
ST6 , ST10 ,
ST23 , and
ST25FG
8 ft-lb (10.8 N•m)
ST26 18 ft-lb (24.4 N•m)
ST30 and
ST32
32 ft-lb (43.4 N•m )
Lubricate Lubricate Lubricate the the the Pump Pump Pump
To reduce the risk of fire or explosion that can result
from static sparking or chemical incompatibility:
• Verify that the hose lubricant is compatible with
your pumped fluid. Do not use glycerin hose
lubricant if pumping strong oxidizer or acids.
• Keep the pump properly filled with genuine
Graco hose lubricant.
NOTICE NOTICE NOTICE
The vent and drain port threads are aluminum. To
help prevent galling, inspect the bolt threads for
foreign material and clean or replace if necessary.
1. Wrap the drain plug (29) threads with PTFE tape
and install the plug into the bottom cover port. Be
sure that it is tight to prevent leakage of lubricant.
2. Use a funnel with a flexible spout to add hose
lubricant through the vent port. The lubricant
level must cover the bottom of the roller.
NOTE: NOTE:
NOTE: If you are using the optional leak sensor,
overfilling may cause nuisance tripping of the
sensor.
See the following table for the correct amount
of lubricant for your pump. Pre-measuring the
correct amount will help prevent overfilling.
Pump Pump Pump
Model
Model Model Amount Amount Amount of of of Hose Hose Hose Lubricant Lubricant Lubricant (approximate) (approximate) (approximate)
ST6
ST10 4.5 fl oz (130 ml)
ST23
ST25FG 12 fl oz (350 ml)
ST26 27 fl oz (800 ml)
ST30
ST32 34 fl oz (1000 ml)
3. Wrap the vent plug (30) threads with PTFE tape
and screw it into the vent port.
Hose Lubricant (order separately)
Glycerin Glycerin Glycerin Silicone Silicone Silicone Volume Volume Volume
24K691
— — —
Quart (0.95 l)
24Y920
— — —
Half Gallon (1.89 l)
24K693 24K686 Gallon (3.79 l)
24M435 24M434
55 Gallons (208 l)
18 3A3367K