Repair
8. Lubricate and install o-ring (211) on inlet seat
(210), then install seat (210) in inlet housing
(209). Use the pin to align the holes.
9. Lubricate and install o-ring (216) on inlet housing
(209), then install the ball (213) and pin (212).
10. Slide the assembled housing into the bottom of
the cylinder.
11. Push the pin (214) through the holes on one side.
Lubricate and install o-rings (208) from the inside,
putting one in each groove on the pin. Then slide
the pin into the second side. The ends of the pin
should be flush to the outside of the cylinder.
Check that the o-rings are seated in the grooves.
Reconnect The Pump
1. If using bung adapter (Accessory Kit 24R650),
install it in the drum cover.
2. Slide the displacement pump down into the drum.
3. Install a gasket (2) on the top of the displacement
pump. Then install the connector (3) on the
displacement pump, with the smaller side down.
Install a clamp (5) hand tight.
4. Install the other gasket (2) on the air motor. Be
sure it is securely on the alignment shoulder.
Hook the air motor shaft on the displacement rod
and lower the air motor into place. Install clamp
(5) hand tight.
Figure 11
3A2977K
17
All manuals and user guides at all-guides.com
