Graco RentalPro 360G 255667, Repair Manual

Page: 7 / 26

Troubleshooting
312520A 7
Problem Cause Solution
Pump output is low Strainer (82) is clogged Clean strainer.
Piston ball is not seating Service piston ball. Manual 310894.
Piston packings are worn or damaged Replace packings. Manual 310894.
O-ring in pump is worn or damaged Replace o-ring. Manual 310894.
Intake valve ball is not seating properly Clean intake valve. Manual 310894.
Intake valve ball is packed with material Clean intake valve. Manual 310894.
Engine speed is too low Increase throttle setting. Manual 312521.
Clutch is worn or damaged Adjust or replace clutch. Page 10 in manual
312521.
Pressure setting is too low Increase pressure. Manual 312521.
Fluid filter (56), tip filter or tip is clogged or
dirty Clean filter. Manual 312521 or 311861.
Large pressure drop in hose with heavy
materials Use larger diameter hose and/or reduce
overall length of hose. Use of more than
100 ft of 1/4 in. hose significantly reduces
performance of sprayer. Use 3/8 in. hose
for optimum performance (50 ft minimum).
Excessive paint leakage into throat
packing nut Throat packing nut is loose Remove throat packing nut spacer. Tighten
throat packing nut just enough to stop leak-
age.
Throat packings are worn or damaged Replace packings. Manual 310894.
Displacement rod is worn or damaged Replace rod. Manual 310894.
Fluid is spitting from gun Air in pump or hose Check and tighten all fluid connections. Rep-
rime pump. Manual 312521.
Tip is partially clogged Clear tip. Manual 311861.
Fluid supply is low or empty Refill fluid supply. Prime pump. Manual
312521. Check fluid supply often to prevent
running pump dry.
Pump is difficult to prime Air in pump or hose Check and tighten all fluid connections.
Reduce engine speed and cycle pump as
slowly as possible during priming.
Intake valve is leaking Clean intake valve. Be sure ball seat is not
nicked or worn and that ball seats well.
Reassemble valve.
Pump packings are worn Replace pump packings. Manual 310894.
Paint is too thick Thin the paint according to the supplier's
recommendations
Engine speed is too high Decrease throttle setting before priming
pump. Manual 312521.
Clutch squeaks each time clutch
engages Clutch surfaces are not matched to each other
when new and may cause noise Clutch surfaces need to wear into each
other. Noise will dissipate after a day of run
time.
High engine speed at no load Misadjusted throttle setting Reset throttle to 3300 engine rpm at no
load.
Worn engine governor Replace or service engine governor
Hour Meter flashing “CHG OIL” Unit requires service See maintenance chart for scheduled
maintenance interval on page 5.