![background image](http://html1.mh-extra.com/html/graco/pulse-25t462/pulse-25t462_instruction-manual_2251576007.webp)
Operation
3A8622B
7
Operation
View Data
The TLM is configurable with Pulse Level
(level.gracopulse.com) to take readings at predefined
times.
After configuring the TLM using the Pulse Level, apply
the magnet to the hot spot, which causes the TLM to
make short chirps (once per second). Hold the magnet
in place until a long beep is heard. The TLM makes
short chirps as it creates a connection with Pulse Level
. 6).
NOTE: Frequent measurements results in shorter
battery life. The TLM may require up to ten (10) minutes
of rest between readings to recharge the internal
electronics.
Manual Measurement
1. Hold the magnet (supplied) to the Hot Spot marked
by the yellow sticker on the side of the device (F
6).
2. Keep holding the magnet to the Hot Spot. The TLM
will chirp once per second and then emit a long
beep.
3. Remove the magnet after the long beep.
Recycling and Disposal
End of Product Life
At the end of the product’s useful life, dismantle and
recycle it in a responsible manner.
• Remove batteries, circuit boards, LCDs (liquid
crystal displays), and other electronic components.
Recycle according to applicable regulations.
• Do not dispose of batteries or electronic
components with household or commercial waste.
• Deliver remaining product to a recycling facility.
F
IG
. 6
Hot Spot