Run Screens
When in Run Mode, the ProControl 1KE displays the
flow rate percent target, actual fluid pressure, and
current flow rate on Screen 1. Screen 2 displays
the batch total and grand total for the flow meter to
which it is connected. Screens 3–6 display a log of
the last 20 alarms.
Run Screen 1
Use this screen to view or reset the flow rate percent
target, and to view the actual fluid pressure and flow
rate. Units are set on Setup Screen 1 and Setup
Screen 2.
Key
Enter the screen.
Flow Rate Percent Target — Operator
settable within the range defined on
Setup Screen 2.
Displays current fluid pressure if
equipped and set up with a pressure
transducer. Otherwise, this field displays
just 3 dashes.
Displays current flow rate.
Move between Run Screens.
Run Screen 2
Use this screen to view or reset the batch totalizer
and to view the grand total flow for the system. The
grand total cannot be reset.
Key
Batch Totalizer - Displays the amount
of fluid measured since the last time the
field was reset to zero.
Reset Batch Totalizer - resets the batch
totalizer to zero.
Grand Totalizer - Displays the grand total
flow for the system. This value cannot
be reset.
Move between Run Screens.
24
3A2614H