Graco Matrix 257464, Installation And Operation Manual

Page: 8 / 14

Connecting Transceiver to Matrix PC
8 313008H
• If your PC does not have enough USB ports for
the Matrix Transceiver(s) connections, a USB
hub must be used. These hubs are not supplied
by Graco.
Installing Transceiver
During system installation, double-faced tape or screws
can be used to allow relocation of the Transceivers to
optimize RF communication.
Once RF communications are confirmed, the Trans-
ceiver can be permanently mounted on wall or ceiling.
1. Remove the top cover from the Transceiver box by
using a flat screw driver to depress the clip (E) on
each side of the cover as shown in F
IG
. 11.
2. Use the back plate as a template for hole place-
ment. Mark holes on mounting surface.
3. Pre-drill holes.
4. Attach back plate to the wall or ceiling using screws.
5. Reattach transceiver box cover.
Transceiver Registration with Matrix PC
Software
Transceiver registration is completed at the Matrix PC.
The software is used to:
• Set the system’s Network ID.
• Set the individual transceiver’s Transceiver ID.
• Assign a Primary Client to each Transceiver.
Complete instructions for registering a transceiver with
the Matrix PC software are provided in the Matrix PC
Software instruction manual.
• If the Transceiver is mounted outdoors, it must
be placed in a protective water proof,
non-metallic outside housing meeting IP65
Standards for outdoor use.
• Be sure to comply with all applicable local,
state, and national fire, electrical, and safety
regulations.
F
IG
. 11
E
F
IG
. 12
Mounting Holes