Repair
3A3169E
17
*This part is shown for reference only. It is not included
in the Throat Seal Kit.
a.
Slide the blade of a small, flat screw driver
under the tapered edge (
te
) of retaining ring (9)
and remove the ring as shown in F
b.
Remove the tapered spacer (10), seal (11), and
spacer (12).
c.
Use the blade of a small, flat screw driver under
the tapered edge (
fe
) of retaining ring (51) to
remove the ring as shown in F
. 28 and remove
the retaining ring.
d.
Remove spacer (12), seal (11), and spacer (12).
DO NOT REMOVE THE LAST RETAINING
RING (51).
e.
Dispose of all parts according to all regulations
for proper disposal.
20. Use a soft brass rod (
br
) and hammer to gently tap
the pump element sleeve (53) out of the pump base
(1) (F
. 29).
Use your hand to catch the sleeve while tapping it
out of the pump base to make sure it does not drop
on the ground or table which could damage the
sleeve.
NOTE:
Be careful not to scratch or damage the sleeve
and/or the pump base housing (1) when tapping the
sleeve out of the pump base or when removing the
o-ring. A scratched or damaged sleeve and or pump
base housing (1) will result in fluid leaking during the
pump operation and will prevent the pump from operat-
ing correctly.
F
IG
. 27
F
IG
. 28
9
10
(install tapered side down)
11
(install lips up)
12
51
12
11
12
51*
(install lips down)
(do not remove from pump)
9
(te)
F
IG
. 29
(ha)
53
(br)
