Graco Lube Master, Instructions Manual

Page: 11 / 44

Setup
3A2781B 11
Fill the System
Fill the pump package reservoir, as described in Fill the
Reservoir , page 9. After it is filled, the remainder of the
system is filled by attaching a hand pump to the system
downstream from the pump manifold block assembly,
then cycle the hand pump until the system is filled.
Clutch Drive Adjustment (if
equipped)
The clutch lever throw is adjustable between 12 and 60
degrees. Table 1 (page 12) provides the minimum/maxi-
mum pump outputs. The actual pump output of the
installation is computed using the Calculating Pump
Output procedure found on page 12.
Use the clutch lever diagram (F
IG
. 7) to determine the
anticipated clutch lever throw angle.
F
IG
. 7: Clutch Lever Diagram