Meter Setup and Operation Instructions
3A1451C
11
b. Press and hold Total
button until CAL stops
blinking.
c. When CAL starts to
blink again, the display
should show 1.00. The
new calibration is com-
plete.
OR
To return to the default calibration:
Press and hold the Total button until CAL
stops blinking and the display shows 0.98 (if
the unit of measurement is gallons, pints or
quarts) or 0.99 (if the unit of measurement is
liters).
NOTE: If an error was made during meter recalibration,
repeat Steps a - c of the recalibration process to recali-
brate the meter again.
3.
Press and hold the Reset but-
ton. The unit returns to Stan-
dard Dispense Mode.
Operation
Dispensing Fluid in Standard Mode
NOTE: All buttons are disabled while fluid is being dis-
pensed.
1.
If the display was blank (in
sleep mode), press and hold
the Total or Reset button. The
amount of the last dispense
appears on the display (F
IG
.
14).
2.
Press and hold Reset button.
0.00
is shown on the display
as shown in F
F
IG
. 14
F
IG
. 15
0D[LPXP:RUNLQJ3UHVVXUHEDU36,
*$/
476
376
/,7(56
5727$/
$872
ti12043a
*$/
476
376
/,7(56
5727$/
$872
0D[LPXP:RUNLQJ3UHVVXUHEDU36,
ti12048a
