LazerGuide 2000
Instructions
9
Calibrating
The procedure may take a few attempts until properly
aligned. Calibration only has to be performed periodi-
cally. Use this procedure for front or rear mounted laser.
Also applies to auto-layout series.
1.
Find an existing long straight line such as a
curb or a previously striped line
. Mark halfway
point and set the target box at far end.
2. At the starting point, make sure your striper frame is
true to your reference line by pushing the machine
about 10 feet while keeping the spray nozzle over or
parallel with the line. Make sure the laser is level,
then adjust the laser left-right until it is centered in
the target box at the far end.
3. Tilt laser downward and swing
spray gun left or
right
until it is in line with the laser. Adjust laser
back to upward position.
4. Position spray nozzle directly over reference line
and maneuver machine left-right until laser is cen-
tered in target box at the far end. Make sure spray
nozzle is centered over line.
