2
308553ZAE
Table of Contents
Warnings ......................................................... 2
Installation...................................................... 4
Operation...................................................... 11
Troubleshooting .......................................... 12
Maintenance ................................................. 14
Service .......................................................... 16
Replacing the Air Valve......................... 16
Repairing the Air Valve ......................... 18
Ball Check Valves .................................. 21
Diaphragm Repair .................................. 23
Pump Matrix ................................................. 26
Additional Diaphragm Pumps ........................ 26
Repair Kit Matrix .......................................... 27
Parts.............................................................. 28
Torque Sequence ........................................ 32
Technical Data and Performance Charts ...... 33
Dimensions .................................................. 35
Graco Warranties .......................................... 36
Graco Information ....................................... 36
Symbols
Warning Symbol
Caution Symbol
WARNING
This symbol alerts you to the possibility of serious
injury or death if you do not follow the instructions.
CAUTION
This symbol alerts you to the possibility of damage to
or destruction of equipment if you do not follow the
instructions.
WARNING
INSTRUCTIONS
EQUIPMENT MISUSE HAZARD
Equipment misuse can cause the equipment to rupture or malfunction and result in serious injury.
•
This equipment is for professional use only.
•
Read all instruction manuals, tags, and labels before operating the equipment.
•
Use the equipment only for its intended purpose. If you are not sure, call your Graco distributor.
•
Do not alter or modify this equipment.
•
Check equipment daily. Repair or replace worn or damaged parts immediately.
•
Do not exceed the maximum working pressure of the lowest rated component in your system. This
equipment has a 100 psi (7 bar) maximum working pressure at 100 psi (0.7 MPa, 7 bar)
maximum incoming air pressure.
•
Use fluids and solvents that are compatible with the equipment wetted parts. Refer to the Technical
Data section of all equipment manuals. Read the fluid and solvent manufacturer’s warnings.
•
Do not kink or overbend hoses or use hoses to pull equipment.
•
Route hoses away from traffic areas, sharp edges, moving parts, and hot surfaces. Do not expose
Graco hoses to temperatures above 82° C (180° F) or below -40° C (-40° F).
•
Do not lift pressurized equipment.
•
Comply with all applicable local, state, and national fire, electrical, and safety regulations.
Tel: 866-777-6060
Fax: 866-777-6383
Springer Pumps, LLC
Website: www.springerpumps.com
Int'l: +001 267 404 2910
