Graco Gusmer Power-Lock 256549A, Instructions - Parts Manual

Page: 21 / 24

Parts
309572S 21
15F144 Hose Wire Jumper
Use the 15F144 Hose Wire Jumper to heat
only the major volume hose, in a wide ratio
system.
To build one complete 50 ft single side heated
hose bundle, order the following parts:
Install as follows:
1. Wrap hose wire jumper (100) around resin
hose (101) in a spiral fashion.
2. Connect resin hose wire (101a) to other
side of Power-Lock connector (100a); see
page 10.
3. Wrap FTS cable (102) around resin hose
(101) in a spiral fashion.
4. Twist hoses (101 and 105) together to pro-
vide strain relief.
5. Repeat steps 1-4 for each length of hose
(101). Connect hoses, electrical connec-
tors, and cables; see Connect Heated
Hoses, page 10.
6. Install one -Lock connector (100a) between
wires; see page 10.
Ref. Part Description Qty
100 15F144 JUMPER, hose wire; includes
two 117789 electrical connec-
tors; 50 ft (15.2 m) long 1
101 chart 2,
page 20 HOSE, resin, heated; 50 ft
(15.2 m) minimum 1
102 15B296 CABLE, FTS 1
103 15C517 HARNESS, hose jumper 1
104 261670 FLUID TEMPERATURE
SENSOR; see page 19 1
105 pur-
chase
locally HOSE, hardener, unheated; 50
ft (15.2 m) minimum; customer
supplied 1
106 pur-
chase
locally CONNECTORS, fluid; as
required to complete assem-
bly; not shown as
req’d
WARNING
Read warnings, pages 6 and 7.
Hoses (101 and 105) must be sized and
pressure rated to meet the requirements of
your system.
Do not operate heated hose (101) at more
than 45 A. If hose is cold, turn current adjust-
ment fully counterclockwise before reheating
hose.
Spray gun must be grounded.