Graco GH 16U277, Repair Manual

Page: 22 / 36

Belt Removal and Replacement (recommended method)
22 332157A
Belt Removal and Replacement
(recommended method)
Removing Belt
a. Place a plastic tie around belt (19).
b. Slowly pull plastic tie toward you while at the
same time slowly pulling engine recoil to rotate
pulleys. It may be necessary to reposition zip tie
and repeat this procedure a few times to com-
pletely remove belt from pulley.
Installing Belt
a. Put belt over lower pulley (6) and align correctly.
b. Line up belt over top left side of large pulley (4).
c. With the palm of your hand, hold the belt snug
to large pulley while at the same time slowly pull
engine recoil to rotate pulleys.
d. Check belt (19) alignment on both large (4) and
small pulley (6). When properly positioned over
pulleys, belt is centered on pulleys and com-
pletely over all grooves.
NOTE: If belt is not aligned properly, to adjust belt, slowly
pull engine recoil while at the same time pushing or pull-
ing belt to reposition over pulley.
Moving parts can pinch or amputate fingers and other
body parts. To avoid serious injury be sure engine is in
OFF position before pulling engine recoil.
19
plastic tie
ti7843a
ti7842a
ti7869a
Properly Aligned
Not Aligned Properly
ti7834a
ti7837a