Operation
8
307427ZAF
Operation
Pressure Relief Procedure
1.
Shut off the air to the pump.
2.
Close the bleed-type master air valve (required in
your system).
3.
Hold a metal part of the dispensing valve firmly to
the side of a grounded metal pail, and trigger the
valve to relieve pressure.
4.
Open the fluid drain valve (required in your system)
to relieve all fluid pressure, having a container ready
to catch the drainage.
5.
Leave the drain valve open until you are ready to
dispense again.
If you suspect that the nozzle or hose is completely
clogged, or that pressure has not been fully relieved
after following the steps above, very slowly loosen the
hose end coupling and relieve pressure gradually, then
loosen completely. Now clear the nozzle or hose.
Flush the Pump Before Using
The pump was tested in lightweight oil, which was left
in to protect pump parts. To prevent contamination of
the fluid you are pumping, flush the pump with a
compatible solvent before using it.
To flush the pump, connect a short hose to the pump
outlet, insert the pump intake into a pail of compatible
solvent, direct the hose into a pail, and start the pump
as explained at right.
Cycle the pump slowly for at least 5 minutes, then stop
and disconnect the air hose. Push up on the ball of the
intake valve (N) to drain the lower part of the pump.
See F
. 4. Turn the pump over to drain the upper part
of the pump.
Starting and Adjusting the Pump
With the air valve (K) or regulator (CC) closed, turn on
the air supply and connect the air line coupler (L). See
F
. 5. Make sure all dispensing valves are
open.
Slowly open the air valve (K) or regulator (CC) until the
pump cycles 5 to 20 cycles per minute. The pump itself
only takes a few strokes to prime. In a large system,
however, the pump may have to be cycled for
several minutes to fill all the lines. Once the entire
system is primed, use the air valve or regulator to
control pump speed and cycle rate; always use the
lowest pressure necessary to get the desired results.
When used for transfer and supply operations with no
dispensing valve, the pump will run whenever air is
supplied.
Pump Shutdown
1.
Disconnect the air line coupler (L).
2.
Relieve the pressure.
WARNING
PRESSURIZED EQUIPMENT HAZARD
The system pressure must be manually relieved to
prevent the system from starting or spraying
accidentally. To reduce the risk of an injury from
accidental spray from the gun, splashing fluid, or
moving parts, follow the
whenever you:Pressure Relief Procedure
•
are instructed to relieve the pressure,
•
stop spraying,
•
check or service any of the system equipment,
•
or install or clean the spray nozzle.
F
IG
. 4
WARNING
To reduce the risk of serious injury whenever you
are instructed to relieve pressure, always follow the
Pressure Relief Procedure at left.
