Operation
42
333587B
In the example above, the low level sensor is set to
Deviation and the empty level sensor is set to Alarm to
stop operation of the pump.
Run Screen Editing Mode
Press the
soft key to enter editing mode.
Press the
soft key to access the Style Definitions
setup screens. See
Style Definitions
on page
for
information about this function.
You can change the style identification number without
going to the Style Definitions setup screens. Enter the
new number using the numeric keypad and confirm it by
pressing the
key.
Press the
soft key to access the Job Log. See
Job
Log
on page
Press the
soft key to exit editing mode.
Heat Run Screen
When Heat is selected for a pump at the System Setup
screen, a Heat Run screen is available. See
System
Setup Screen
on page
. Use the ADM directional
keypad (BH) to go to the Heat Run screen.
The Ram Heat Run screen is identical to the Tandem
Heat Run screen except for the Menu Bar as shown
below.
NOTE:
The zone must be enabled at the Heat Setup
screen 1 to be displayed on the Heat Run screen. See
Heat Settings
on page
.
The pump heat zones are shown on the left side of the
screen and the zones for the other system components
are shown on the right. The number in the box next to
the pump is the pump number.
For each component, the number outside the left
bracket is the connector number. The number just inside
the left bracket is the zone number.
The temperature reading inside the box is the zone
setpoint/setback temperature. It is the setpoint to which
control is heating the zone when the zone is turned on.
When the system is placed in setback, the temperature
displayed in the box is the setback value.
