Setup
333587B
23
Setup
It is important to set up the parameters of your system
before operating the E-Flo iQ system. These are
accessed through the iQ Menu. After starting up the
ADM, press the
key from the Run screen to go to
the iQ Menu screens. Refer to
iQ Menu
on page
System Setup Screen
Press the
soft key at the iQ Menu screen 2 to
access the System Setup screen.
Press the
soft key to enter editing mode.
Use the drop down menu to select the type of system as
either Ram or Tandem.
NOTE:
Changing the system type resets the pumps in
the system.
When you select Ram
, the only action required at this
screen is if the pump has a heat module installed. Press
the
key in the Heat box to configure it for heat.
All other fields are automatically set when the blue token
is inserted on an installed system. The System is
displayed as Ram. The box below the iQ icon next to the
System field indicates that it is an E-Flo iQ system.
The Pump shows as Installed. The Serial Number
should match the serial number printed on the driver ID
tag. As a backup to the driver serial number, the serial
number of the current board will be displayed instead.
The serial number for the control board is also displayed
in the detailed software status screens. See
Advanced
Setup Screen 4
on page
.
When you select Tandem
, a field for the second pump
is displayed on the screen showing Uninstalled. Select
Installed from the drop down menu.
To prevent personal injury from pressurized fluid such
as skin injection or splashing fluid, make sure that all
components in your system are rated to the maximum
pressure the system is capable of attaining. All
components must be rated for maximum pressure
even if the pump is operated below maximum
pressure.
NOTICE
To prevent damage to ADM buttons, do not press the
buttons with sharp objects such as pens, plastic cards,
or fingernails.
NOTICE
To prevent damage to components in the system, all
components must be rated to the maximum pressure
the system is capable of attaining.