Setup
Setup
Setup Screen
Screen
Screen 7
7
7
Use this screen to set the maintenance interval (in
cycles) for each pump. The screen also displays the
current cycle count. Error code MND_ appears when
the counter reaches 0 (zero).
Figure 17 Setup Screen 7
Setup
Setup
Setup Screen
Screen
Screen 7
7
7 Key
Key
Key
For systems with multiple pumps and
one display, select the pump (1 to 8)
from the menu.
NOTE: Three phase systems do not
support multiple pumps.
Set the maintenance interval (in cycles)
for each pump.
Setup
Setup
Setup Screens
Screens
Screens 8
8
8 and
and
and 9
9
9
Use these screens to set up the pressure transducers.
The screens are identical, except Screen 8 is for
transducer 1 and Screen 9 is for transducer 2.
Selecting a transducer and a pump activates closed
loop pressure control.
NOTE:
NOTE:
NOTE: Closed loop pressure control requires the
transducer to be installed near the pump outlet.
Figure 18 Setup Screens 8 and 9 (Screen 8 shown)
Setup
Setup
Setup Screens
Screens
Screens 8
8
8 and
and
and 9
9
9 Key
Key
Key
Select from the menu options (500 psi or
5000 psi) to enable the transducer.
This option enables closed loop pressure
control and assigns the transducer to a
pump.
• For systems with multiple pumps and
one display, select the pump (1 to 8)
from the menu.
• For three phase pumps, select pump
1.
Enter the calibration scale factor from the
transducer label.
Enter the calibration offset value from the
transducer label.
Displays the current transducer reading.
16
3A2527H
