![background image](http://html.mh-extra.com/html/graco/comfort-sport/comfort-sport_instruction-manual_2250327012.webp)
REAR-FACING
INSTALLATION WITH
LATCH
12
1
7
6
5
4
3
2
LATCH
belt must be routed through opening in
child restraint for
rear-facing
mode.
(see page 29, fig. d
).
Belt must lay flat and not be twisted.
Adjust child restraint to recline position
(see fig. a and page 25, fig. g
) Place
rear-facing
on vehicle seat equipped with
LATCH
anchors.
For ease of installation, extend
LATCH
belt to its
maximum length.
Hook connectors to vehicle lower anchors
(fig. b). Pull connectors to be sure they are
securely attached to the anchor points. (fig. c).
Press down firmly in center of child restraint
while pulling
LATCH
adjustment belt. (fig. d).
Pull front to back and left to right at belt path
to check for secure installation
(fig. e)
. The
child restraint should not move side to side or
forward more than 1 inch (2.5 cm).
Check that the lower anchorage belt stays
tight and does not slip from the tightened
position. If it does not stay tight, try another
seating position or contact Customer Service.
Check level indicator on child restraint.
Vehicle must
be on level ground and child in
child restraint when checking level indicator.
Ball MUST be entirely in green zone (fig. f). If
necessary, place rolled towels under child
restraint, at vehicle seat crease, until entire ball
is in green zone. Then re-check level indicator.
DO NOT use tether
rear-facing
. Tether
must
be stored (see “Tether Storage” page 38).
Perform this test every time you drive with your
child.
Summary of Contents for Comfort Sport
