Refilling
Refilling
Refilling the
the
the Pot
Pot
Pot with
with
with Abrasive
Abrasive
Abrasive
1.
Close the abrasive ball valve (M).
2.
Turn the selector valve to OFF.
3.
Open the pot dump valve (J) to drain water from
the pot.
NOTE:
NOTE:
NOTE: Be prepared to capture the water that
will be drained from the pot. All disposals must
comply with national, state, and local regulations.
4.
Engage the pop-up pin by compressing the
spring and turning the handle 90° to hold the
pop-up in the open position.
5.
Add the abrasive (see
Technical Specifications, page 66
for capacity
information) and continue to step 8 from
Setting Up the Equipment, page 13
.
Shutting
Shutting
Shutting Down
Down
Down
1.
When you have finished blasting, perform wash
until all of the abrasive is flushed from the blast
hose. See
Using the Wash Feature, page 19
.
2.
Turn the selector valve to OFF, and with the
abrasive ball valve closed, continue to blast until
water is cleared from the hose. This is to dry the
inside of the hose for storage.
3.
Perform
Pressure Relief Procedure, page 10
20
3A3489A
