Warnings
Warnings
Warnings
The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The
exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific
risks. When these symbols appear in the body of this manual or on warning labels, refer back to these
warnings. Product-specific hazard symbols and warnings not covered in this section may appear throughout
the body of this manual where applicable. See your component manual for warnings that are specific
to those components.
WARNING
WARNING
WARNING
FIRE
FIRE
FIRE AND
AND
AND EXPLOSION
EXPLOSION
EXPLOSION HAZARD
HAZARD
HAZARD
Flammable fumes, such as solvent and paint fumes, in the work area can ignite or explode.
Paint or solvent flowing through the equipment can cause static sparking. To help prevent fire
and explosion:
• Use equipment only in a well-ventilated area.
• Eliminate all ignition sources such as pilot lights, cigarettes, portable electric lamps, and
plastic drop cloths (potential static sparking).
• Ground all equipment in the work area. See Grounding
Grounding
Grounding instructions.
• Never spray of flush solvent at high pressure.
• Keep work area free of debris, including solvent, rags, and gasoline.
• Do not plug or unplug power cords, or turn power or light switches on or off when flammable
fumes are present.
• Use only grounded hoses.
• Hold gun firmly to side of grounded pail when triggering into a pail. Do not use pail liners
unless they are antistatic or conductive.
• Stop
Stop
Stop operation
operation
operation immediately
immediately
immediately if static sparking occurs or you feel a shock, Do not use
equipment until you identify and correct the problem.
• Keep a working fire extinguisher in the work area.
Static charge may build up on plastic parts during cleaning and could discharge and ignite
flammable vapors. To help prevent fire and explosion:
• Clean plastic parts only in a well-ventilated area.
• Do not operate electrostatic guns in the equipment work area.
ELECTRIC
ELECTRIC
ELECTRIC SHOCK
SHOCK
SHOCK HAZARD
HAZARD
HAZARD
This equipment must be grounded. Improper grounding, setup, or usage of the system can
cause electric shock.
• Turn off and disconnect power at main switch before disconnecting any cables and before
servicing or installing equipment.
• Connect only to a grounded power source.
• All electrical wiring must be done by a qualified electrician and comply with all local codes
and regulations.
4
3A4030C
