![background image](http://html1.mh-extra.com/html/graco/24r707/24r707_instructions_2253128002.webp)
All written and visual data contained in this document reflects the latest product information available at the time of publication.
Graco reserves the right to make changes at any time without notice.
2ULJLQDOLQVWUXFWLRQV
This manual contains English. MM 334790
Graco Headquarters: Minneapolis
International Offices: Belgium, China, Japan, Korea
GRACO INC. AND SUBSIDIARIES • P.O. BOX 1441 • MINNEAPOLIS MN 55440-1441 • USA
Copyright 2015, Graco Inc. All Graco manufacturing locations are registered to ISO 9001.
www.graco.com
Revision B, August, 2015
Installation
1.
Install the bleed-type vented air shutoff valve and fil-
ter at the 1/4 npt female system air inlet.
NOTE: The system must have a bleed-type ball valve
that bleeds pressure downstream when closed. Other-
wise, the supplied air will need to be disconnected from
the system whenever the pressure is relieved. The
direction of flow is indicated on the valve. If installed
backwards, the valve will not vent properly.
NOTE: The system must use an air filter with a mini-
mum flow rate of 30 scfm.
2.
If using the same air for the applicator(s), install a
tee in the air line before the ball valve. There should
not be anything between the ball valve and the sys-
tem (except the filter, if installed). See applicator
manual for applicator air pressure requirements,
and use a regulator before the applicator to
decrease air pressure if necessary.
3.
Use the optional elbow fittings (6, 7) and pipe nipple
(8) to alter the orientation of the incoming air line, fil-
ter, and ball valve.
4.
Close the ball valve.
5.
Attach a 3/8 in minimum air supply line to the ball
valve.
NOTE: Air supply pressure must be between 80 psi
(550 kPa, 5.5 bar) and 100 psi (690 kPa, 6.9 bar). Rec-
ommended pressure is 100 psi (690 kPa, 6.9 bar).
NOTE: If air pressure is expected to drop below (550
kPa, 5.5 bar), use air reservoir kit 16W366 to allow the
system to operate down to 60 psi (414 kPa, 4.1 bar).
Graco Information
For more information about InvisiPac, visit www.InvisiPac.com.
For technical assistance or customer service, call toll free: 1-800-458-2133.
TO PLACE AN ORDER, contact your Graco distributor or call to identify the nearest distributor.
Phone: 612-623-6921 or Toll Free: 1-800-328-0211 Fax: 612-378-3505