![background image](http://html1.mh-extra.com/html/graco/248113/248113_instructions-manual_2253114004.webp)
Installation
4
309930C
13. Strip 9/16 in. of insulation with 8-gauge wire stripper
from both sides.
14. Inspect wires. If not black or in burnt condition, con-
tinue to step . If wires appear black or in burnt condi-
tion, repeat step 13. Do not exceed 6 in.
17. Slide shrink tube over splice.
18. Using a heat gun or hair dryer, heat shrink tubing
around splice. If neither is available, wrap entire
length of shrink tubing with electrical tape.
19. Slide transformer back and install bolts to bottom.
20. Replace Reactor front panel.
12. Take larger 8-gauge wires and cut pins from both
sides.
15. Install shrink tube over one end.
Wire
Cut wire
Male pin
Wire
Cut wire
Female pin
Shrink tubing
Wire
Wire
16. Install splice between the two wires and tighten
screws.
Wire
Shrink
Splice
Wire
tubing
Summary of Contents for 248113
Page 5: ...Installation 309930C 5...