309406C
INSTRUCTIONS
INSTRUCTIONS
KEEP FOR REFERENCE.
Read this and all related manuals for
important warnings and instructions.
10 mph (16 kph) Maximum Operating Speed
Battery Kit 245343
The
Battery Kit
allows the LineDriver
t
electrical
system to power additional electrical equipment. The
LineDriver generates approximately 70W at full
throttle, the light consumes 55W. The electrical sys-
tem automatically keeps the battery charged when
light and/or additional electrical equipment are not in
use. If the light and additional electrical equipment
exceed 70W consumption for long periods of time,
without battery recharge from the electrical system, it
may be necessary to charge battery with an external
charger.
S
The LineDriver will not charge a dead battery;
battery must be initially charged before use.
The electrical system charges the battery bet-
ween 8 to 14 volts.
S
Connect additional 12 volt DC equipment con-
nections directly to battery. Use only 2-wire
devices that are ground isolated. Never con-
nect ground wires or any wires to frame. Use
appropriate fuse on all additional equipment.
S
The switch on the circuit board switches the
light from regulated power from the engine
(BACK – slide switch towards engine), to DC
power from the battery (FORWARD – slide
switch away from engine). The battery will not
charge when switch is in BACK. If the battery
becomes dead at any time, slide the switch to
BACK for the light to work.
S
Replace battery only with (completely sealed
lead acid type) Graco 115753.
Trouble Shooting: with battery installed
Problem
Possible
Cause
Solution
Battery does
not hold charge
Bad battery
Replace battery
Battery voltage
too low
BACK/FOR-
WARD switch is
at BACK
Slide switch to
FORWARD.
Charge battery
with battery
charger
Light does not
light
Bad bulb
Replace bulb
Bad battery
connections
Slide switch to
BACK. If light
works, check
battery voltage.
If light does not
work and bulb
is good, check
battery connec-
tions.
GRACO INC.
P.O. BOX 1441
MINNEAPOLIS, MN
55440–1441
E
COPYRIGHT 2001, GRACO INC.
Graco Inc. is registered to I.S. EN ISO 9001
