Instructions - Parts List
INSTRUCTIONS
This manual contains important
warnings and information.
READ AND KEEP FOR REFERENCE
Graco Inc. P.O. Box 1441Minneapolis, MN 55440-1441
COPYRIGHT 2001, Graco Inc.
Graco Inc. is registered to I.S. EN ISO 9001
309360
Rev. A
)LUVW FKRLFH ZKHQ
TXDOLW\ FRXQWV
Push/Pull Fan Air Valve Kit
Part No. 244912
Converts the PRO™ Xs2, PRO™ Xs3, and PRO™ Xs4 Electrostatic Air Spray Guns to a 2-position fan air valve, to
allow quick spray pattern changes.
Pressure Relief Procedure
1.
Turn the ES ON/OFF valve OFF.
2.
Turn off the air bleed valves to the fluid source and
to the gun.
3.
Trigger the gun into a grounded metal waste con-
tainer to relieve the fluid pressure.
4.
Open the pump drain valve, having a waste con-
tainer ready to catch the drainage. Leave the pump
drain valve open until you are ready to spray again.
5.
If the nozzle or hose is completely clogged or pres-
sure is not fully relieved, slowly loosen the hose end
coupling. Now clear the nozzle or hose
Installation
1.
Remove the fan air adjustment valve. See Fig. 1.
Fig. 1: Remove Fan Air Adjustment Valve
WARNING
Pressurized Equipment Hazard
Before installing this kit, follow the
Pressure Relief
Procedure
below to reduce the risk of fire, explosion,
electric shock, and splashing of fluid in the eyes or on
the skin.
TI1546A
ti1266a
I O
ES
Fan Air Adjustment Valve
