Installation
308943E
3
Installation
Assemble the swivel wheel kit according to the following
steps:
1. Put front of cart on cement block or other type of
support in place of removed caster wheel.
2. Fig. 2. Drill two holes through the right side of
chassis frame as viewed from front.
Fig. 2.
3. Fig.3. Mount cable bracket (11) on right side of cart
(110), as viewed from front, with two flange screws
(15) and two lock nuts (16).
4. Slide actuator lever (9) on cart handle (H) and
tighten. Install handle grip (18). Replace other
handle grip if needed.
5. Insert two cap screws (13) into front caster bracket
(12) and mount on front of cart (110).
6. Assemble swivel caster (1) to cart (110) and cap
screws (13) extending though cart. Fasten with two
lock nuts (14) and washers (19) and tighten.
7. Install one end of cable (10) in actuator lever (9).
8. Route cable (10) from actuator lever (9) down
handle and between cart base (110) and motor
mount plate (108) to swivel caster (1). Fasten cable
to cable bracket using nut provided with cable.
9. Install compression spring (8) over cable wire and in
front of caster wheel (1).
10. Fig. 4. Install wire stop (7) on cable wire (10) and
finger tighten wire stop screw.
Fig. 3.
