Spacebar Hanging Adapter Setup Procedure
1. Thread the 4 conductor microphone cable through the wire tube and have it exit through the
oval opening. We recommend using the Canare L-4E6S / L-4E5C Star Quad cable for this
application. Refer to fig. 9 'Hanging Adapter Wiring Detail'.
2. Pull enough of the wire through the oval opening to facilitate splicing to a two conductor
microphone cable for the Left and Right lead wires.
3. Splice on the Left and Right lead wires and then terminate to the female XLR connectors.
4. Next thread the wire tube assembly into the stand mount hole on the Spacebar.
5. Establish how much wire loop will be needed for the wires to reach the microphones and then
tighten the thumb screw so that it binds into the wire insulation. This will secure the wire and
keep it from slipping back through the wire tube.
6. Install the 6-32 x 3/8” button head screws in the ends of the bar leaving about 1/16” of thread
showing.
7. Clip the swivels on the ends of the monofilament yoke to the 6-32 button head screws. The
system is now ready to be hung.
Caution: Use extreme care in securing the hanging cable. A
falling Spacebar assembly with microphones can cause
severe injury or death.
Stereo Spacebar User Manual Revision C
Page 12 of 13
