Configuring the CT-24 – Done !!
Before you receive your CT-24 GPS tracking
kit, it will have already been activated and
pre-programmed by your GPS tracking
service provider. This will have set up such
parameters as :
1)
GPS report settings
(e.g. moving and
stationary report interval, total number
of reports, stop and stationary alert
intervals, etc.)
2)
Vibration Sensor
(e.g. wake up delay,
report interval, total number of
reports, power saving mode, etc.)
3)
GPS tracking server
(e.g. GPS tracking
device serial number, Internet server
address and port, wireless data
protocol, Username & Password, etc.)
4)
Wireless Data SIM card
(e.g. wireless
carrier gateway, card activation, etc.)
5)
Web-based GPS Tracking Account
(e.g.
Username and Password, etc.)
How to Start Tracking Your CT-24
1.
Turn on the tracker. The Power ON/OFF
switch is on the side of the CT-24.
2.
Position the GPS tracker in a suitable
place to receive a good GPS signal and
wait for 1 to 2 minutes for the CT-24 to:
a.
Connect to the local GSM mobile
wireless network (constant Red
LED on CT-24).
b.
Acquire its first GPS position fix
(constant Blue LED on CT-24).
3.
Log on to your GPS tracking account.
Note: Your login information should have
been provided to you as follows:
Login URL: __________________________
Username: __________________________
Password:
__________________________
Please write down your login information
and keep it in a safe place.
