4
Power Generation Installation Guide Version 2.0.0 - July 2016
2. Installation & Components
2.1 Installation
Locate an area to mount the antenna less than 3 meters from the Mobile Transmitting Unit (MTU). Mount the
antenna, using the Antenna mounting bracket (BK9990), and run the cables to MTU.
a) Mount the MTU in an area where there is easy access to antenna cables and the battery or power source.
b)
GPS
Connect the Blue colored wire to the J1 connector on the MTU.
c)
GSM
Connect the Yellow colored wire to the J2 connector on the MTU if connecting a GMS device.
or
SAT
Connect the White colored wire to the J3 connector on the MTU if connecting an Iridium device
Connect cables to mounting location of the MTU.
2.2 Power Harness
(HN9040) (See the Wiring Diagram)
a) Connect the power harness (HN9040) (Gray Connector (A)) to the MTU at receptacle “A”
b) Connect the RED wire directly to a continuous 12-24 vDC source or the positive battery terminal.
c) Connect the BLACK wire to a good ground, preferably the negative battery terminal.
Note: The connector and receptacle are keyed so that they can only go together one way. Please be sure to line up the
guides on the connector with the slots in the receptacle when connecting the harness to the MTU.
J1
J2
J3
4-pin
Deutsche
connector
A