6
2. Install the
s by matching
the correct polarity, as shown.
3. Replace the cover.
Replace b
s when any of the following occur:
•
The
shows on display
•
The display dims
•
The display does not light up
CAUTION
•
Remove
eries from monitor if they will not be used for a long period of time.
•
Do not dispose of b
s in
fire
. B
s may explode or leak.
•
Discard used b eries according to your local recycling guidelines.
Oscillographic Measuring method
This product uses the Oscillographic Measuring method to detect blood pressure. Before every
measurement, the unit establishes a “zero pressure” equivalent to the air pressure. Then it starts
g the arm c
uff
, meanwhile, the unit detects pressure
s generated by beat-to-beat
e, which is used to determine the systolic and diastolic pressure, and also pulse rate.
The device also compares the longest and t
me intervals of detected pulse waves to
mean
e interval, and then calculates standard
. The device displays a warning signal with
the reading to indicate the d
n of irregular heartbeat when the
differenc
e of the
e intervals is
over 25%.
g date, me and measurement unit
It is important to set the clock before using your blood pressure monitor, so that a me
stamp can be assigned to each record that is stored in the memory. (year: 2000-2050, me:
24H)
1.
When the unit is o
ff
, press and hold “SET” for
3 seconds to enter the mode for YEAR
2.
Press the “MEM” to change the YEAR.
3.
When you get the right year,
press “SET” to set the year.
SET
Yr
MEM
Yr
SET
Yr