Device Description HG G-71450/1/3/5-A | English, Revision 02 | Date: 06.06.2019
61
Transponder Programming – Chapter 10
10
Transponder Programming
The transponder antenna can also be used to program compatible transponders (see
Table 3 on page 10). This is a two-stage process:
1.
Move the transponder to the correct position underneath the antenna
2.
Trigger the programming process in the transponder antenna (interface tele
-
grams or monitor program)
For transponders that are yet unprogrammed no level is shown respectively the LED
Data is not lit even when the transponder is in the antenna‘s reception area.
10.1 Positioning of the Transponders using HG G-71325 as
an example
For best possible results when programming the transponder, hold the transponder
approx. 5 cm below the antenna. While doing so the antenna must be supplied with
power. Take care not to position the transponder centrally under the antenna, as
there is a blanking interval in the field in which programming is not possible (see also
Figure 5 on page 15). The aim is for the transponder to be in detection area I (see
Figure 2 on page 13).
Figure 30
Notes for transponder programming
The further procedure differs depending on the antenna variant. The telegrams of
the integrated interface or the monitor program can be used alternatively for each
variant.
Distance:
Off-center
(side irrelevant)
approx.
Antenna
Example: Transponder HG G-71325
5 cm
