Software
English, Revision 04, Date: 19.01.2015
35
-
Cs(
) (section 5.3.2.6 on page 40)
-
display Histogram (
/
) (section 5.3.2.7 on page 41)
-
display Histogram (
/
) (section 5.3.2.8 on page 42)
-
(
)oad Userparameters to EEProm (section 5.3.2.9 on page 43)
-
(
) Import / (
) Export User Parameter (section 5.3.2.11 on page 43) and
-
(
)pdate Firmware (section 5.3.2.10 on page 43) and
-
P(
)int Parameters (section 5.3.2.12 on page 43).
5.3.2.2
(S)erial Output
Any changes effected to this sub menu are activated only after a system reset (switch-
ing the antenna off and on again). Depending on the alterations made, it may become
necessary to use a different baud rate / different text document for the startup of the
monitor (section 5.3.1 on page 31).
Figure 18
Menu: (S)erial Output
Pressing
switches between 19200 and 38400 Bd. Pressing
selects between
high byte first and high byte last. When using this system together with a Siemens PLC
it is essential, that this parameter is 0 (High Byte first).
enables influencing the structure of the output telegram. The telegram length is set
automatically.
According to the values given in Table 2 „Data words in a telegram with 21 byte length“
on page 19, it is possible to set the customized contents of the telegram
using
hexadecimal addition. The parameter sequence cannot be influenced. It is always the
same sequence as shown in the table!
S:0007 D:-007 D_Y:+32767 Code: 00000000 Read: 0: N: 1
Frx[/Hz]:66760 Ftx[/Hz]:127990 Csel:1
U[/mV]:23100 I[/mA]: 530 T[Grd.C]:+24 E: 0002 Noise 0
(B)audrate: 19200
(O)rder of Data Transfer (0= HiByte first): 0
(T)elegram Content Mask [0..1FFF]: 00001fff
(D)isplay Telegram Content
(C)har-Delaytime [1..220ms]: 220
(P)rocedure Transparent
Co(n)tinous Telegrams 1
(S)erial Data Period [4.500mS]: 8
(F)reeze Values for n Telegrams:[0..10]: 0
(Q)uit Menue
