Gotie GPL-200, User Manual

Page: 6 / 12

UP for the callus remover. (pic. 1). Use the callus remover (fine)
Remove the protective cover from the callus remover. Turn on the
unit by sliding the ON/OFF switch down for the callus remover (pic.
2)
6. Gently rotate (back and forth or side to side (pic.3) the
callous/corn/hard skin area for 2-3 seconds. Dot not piress hard-
gently glide the unit over desire area. The unit will stop if it is
press too hard on the skin. Stop and check if you have achieved
the softness you desire. If not, go over the area for 2-3 more
seconds and check again. Continue to use this method until the
level of smoothness is obtained.
Warning: stop usie if skin becomes sore or inflamed.
Warning: Do not use on skin for more than 2-3 seconds at
a time.
1. Turn the unit off.
2. Rinse the skin wet towel to get rid of the excess dead particles.
3. To clean this callous remover, please see the cleaning section.
4. Keep the protective cover on your unit when it is not in use.
CHANGING THE ROLLERS GRINDING HEAD
Change the rollers grinding head as needed for best result. the Rollers
Grinding Head last for a few sessions depending on frequency of use and
size of area being treated. Replace as needed. Make sure the unit is
turned off before replacing the rollers grinding head.
1. One hand hold the head, another hand press in the release button,
on the side of the unit, the head will tack out (pic. 4 & 5).
2. Place a new roliers grinding head into the unit until you hear a
"click' sound. Be sure to insert the new head into the unit, it has
been firmly installed. Changing the rollers grinding head
Note: Do not turn your unit nn if the rollers rrinding head is not
attached.
6