GoStand Series 1 dual motor Sit-Stand desk
Assembly Instructions
www.gostand.co.uk For help email: [email protected] Page 7 of 7
TROUBLESHOOTING
--Reset Instructions--
If experiencing error messages showing on the keypad or no response when trying to raise or lower:
•
Unplug the power cord and hold the down key for 20 seconds.
•
Plug the power cord back in.
•
Press and hold the DOWN button on the Keypad until the desk reaches its lowest height.
Release the DOWN button. Press and hold the DOWN button again until the LED
display reads “RST” or about 10 seconds on non-LED handset models. Release the DOWN
button. Press and hold the DOWN button again until the desk lowers a little bit more, slightly
rises and stops. Release the DOWN button. Your desk is now ready to use.
•
The keypad will then display the current height, and you should be able to operate it now.
•
You may need to do this if the desktop is ever unplugged or loses power.
m that all wired connections are secure (legs
to cables, cables to control box). Then perform the reset procedure above. If the error message persists
after the reset procedure of if the height between the legs exceeds 30mm stop the reset procedure and
contact [email protected] www.gostand.co.uk
If the handset displays “Hot”, let the base cool down for 20 minutes.
If the desk seems to be uneven, try the reset instructions above. If that does not work you may need
to adjust the levelers at the bottom of the foot.
Keep Children away from electric height-adjustable desks, control
units and handsets. There is a risk of injury and electric shock
This product is designed with a duty cycle of 10%
(2 min. on, 18 min. off)
In the event of a power outage or if the power cord is unplugged,
a manual reset may be necessary (see Reset Instructions above)
Do not open any of the components: lifting columns, control box, or
handset. There is a danger of electric shock
Keep all electrical components away from liquids
i
i
!
!
!
