GMC-I Messtechnik GmbH
33
StoP – Sequence Stop Address
Functions
•
The end of a range within which memory locations or content
will be deleted or added
•
The
SEQUENCE
is always
defined by means of a start address and a stop
address.
•
Memory location at which a
SEQUENCE
will be ended
•
The stop address
can correspond to
any memory location from 11
to 255
.
•
The
stop address
is selected immediately
before initially starting a
new
SEQUENCE
.
•
The
last selected stop
address is always valid for any given
sequence
, regardless of the point in time at which the
sequence
is started.
•
The stop address for a
sequence change
can be selected
independent of the stop address.
!
The contents of the memory location with the
stop
address are
executed as the last function (reP
Setting Parameter
11
Lowest possible memory location
stop
address
255
Highest possible memory location
stop
address
Settings
(see sequence settings and execution on
☞
Procedure
for selecting
StoP,
see also chapter 4.7:
!
The
StoP
display appears in the window for the SEq function,
along with a related numeric parameter.
Figure 4.7.3 g
Path to Stop Address Selection
☞
Select the memory location with the <
> key or the <
> key.
☞
After selecting the value, jump to the next or the previous
sequence function by pressing the
<FUNCTION>
key, or by
simultaneously pressing the
<FUNCTION>
key and the
<
> key
or the <
> key.
!
The last selected and displayed value for the numeric stop
address parameter is used as a default setting.
rEP – Sequence Repetitions
Functions
•
Defines the number of
SEQUENCE
repetitions from the
start
address to the
stop
address.
•
The
SEQUENCE
is run from the selected start address to the
stop address. If repetitions have been programmed, the
pointer automatically jumps from the stop address back to the
start address, and the sequence is started over again.
•
The
rEP
value is stored to the
setup
memory as a device
setting with the
SAVE
key.
Setting Parameter
cont
Continuous repetition until the
sequence
is stopped
manually (page 36 ff,) or by means of computer
control (page 70)
1 ... 255
Number of possible repetitions
Settings
(see sequence settings and execution on page 35)
☞
Procedure
for selecting
rEP, (
!
The
rEP
display appears in the window for the SEq function,
along with a related numeric parameter [s].
Figure 4.7.3 h
Path to rEP Setting
☞
Select the desired number of repetitions with the <
> or the
<
> key.
☞
After selecting the value, jump to the next or the previous
sequence function by pressing the
<FUNCTION>
key, or by
simultaneously pressing the
<FUNCTION>
key and the
<
> key
or the <
> key.
!
The last selected and displayed value for the numeric
parameter (number of repetitions) is used as a default setting.
Possible selections for the
memory location stop address
From the SEq function group
Select the
stop address
FUNCTION
+
From the SEq function group
Select a value for
number of repetitions
FUNCTION
+
Summary of Contents for SSP 120 Series
Page 2: ...2 GMC I Messtechnik GmbH ...
