2
GOSSEN METRAWATT GMBH
1
Display (LCD)
2
ON|OFF key
!
Cursor position to the right
Operating mode menu:
↵
(ENTER)
Changeover to sub-menus /
acknowledgement of entries
3
"
Increase values
Operating mode menu:
Selection of individual menu items
against direction of flow
4
#
Decrease values
Operating mode menu:
Selection of individual menu items
in direction of flow
5
ESC key for selecting ranges or functions
$
Cursor position to the left
Operating mode menu:
Exit menu level and return to a higher level,
exit parameters configuration
without saving data
6
Rotary switch
for simulation functions
7
Connector jack for NA5/600 power pack
8
Connector jacks for calibrator output
9
DKD calibration mark, see page 4
Symbols used in the Digital Display
1
Main display with decimal point and polarity display
2
Auxiliary display with decimal point and polarity display
3
: Simulator in continuous operation
4
NUM: Numeric entry of output signal
5
INT:
Interval sequence active
6
RAMP:Ramp function active
7
ON:
Calibrator output is active
8
Unit of measure (if blinking, refer to chapter 13 on page 24)
9
SOURCE: Current source is active
10 SINK: Current sink is active
11 Ni/Pt1000: Selected temperature sensor
12 TC:
Thermocouple
13
:
Low battery voltage (< 3.5 V), replace batteries
1
2
3
4
5
6
7
8
No measuring input !
Do not apply interference voltage
except current sink
!
9
1
2
13
6
3
8
4
5
7
12 11 11
10
9
8