129737
Instructions for Use
21
dryer so that the drum light will turn off. (
models with illuminated drum).
x
dryer consumption when used at a lower
electric power rate can additional save the
energy.
For your convenience the chart below indicates
approximate values for 5 kg of test laundry at
different washing machine spin stages.
(program
– dry for closet)
RPM/mi
n
extent of
moisture
drying time
in min
energy
consumption
in kWh
l
%
extra
ctor
dryer
condensa-
tion dryer
extract
or
dryer
condensa-
tion dryer
800
3,5
70
110
100
3,35
3,65
1000
3,1
62
98
90
3,0
3,2
1200
2,8
55
88
80
2,7
2,9
1400
2,5
50
80
72
2,4
2,6
1600
2,4
47
75
70
2,3
2,5
Measured quantities may differ from the indicated
because of differences in the type and quantity of
laundry, spinning, voltage supply oscillation, as
well as the temperature and humidity of the room.
Cleaning and Maintenance
Before cleaning, disconnect the appliance from
power supply.
Housing
Wipe the housing with a soft wet cloth and mild
cleaning agent. Do not use aggressive cleaning
agent which could damage the surface.
Replacement of the lamp
(only some models have it)
x
Before you replace the lamp disconnect the
appliance from the power supply or turn-off
the safety fuse.
x
Open the door.
x
Undo the lamp cover (inside the door aperture).
x
Replace the lamp. Maximum possible power of
the lamp is 10 W.
x
Firmly screw the lamp cap again. Mind that the
lamp cap together with a seal is well
embedded, otherwise moisture can come inside
and cause a short circuit.
Fluff Filter
After each drying remove the fluff trap filter from
its cabinet located inside the door and gently wipe
over the filter with a soft cloth or soft brush to
remove the coating of fibers and threads.
Clean the filter cabinet as well.
Fluff trap filter can also be cleaned under the
running water, however it must be dried before
being replaced.
NOTE
Fluff on the filter is a consequence of normal
wear of the material and has nothing to do with
drying in the machine. When drying the laundry
out in the open, the fluff is carried away by the
wind.
Cleaning of extractor dryer
If your drier is placed in a room with poor air
ventilation or if it often operates, dust deposit in
the interior of the appliance (on the bottom and in
the outlet pipe, which could be the cause for
malfunctions. So once a year, wipe the dust in the
interior of the drier.
Cleaning procedure
Pull the plug out of the wall socket.
Clean (suck out) the moist air outlet through
the opening on the rear or side wall (A) and the
vent pipe.
Undo the screws and remove the cover (B).
Clean (with a vacuum cleaner) the bottom of
the drier and parts on the bottom.
Reinsert the cover in reverse order.
