Gorenje WA 63 Series, Instructions For Use Manual

Page: 17 / 32

141576
it had been interrupted.
Permanent suspension - change of program
By turning the program selector to the position “0” the program
is permanently suspended. Consequently you may select a new
program
(see Program selection).
• Failures
Program is suspended in case a failure occurs. This is
signalled by the relevant reading on the display and a sound
signal (see cf. Troubleshooting).
• Power failure
At electric cutout the program is interrupted, however, after the
power supply has been re-established, the program operation
automatically proceeds.
If a power failure occurs when the drum is still full of
water, be careful not to open the door before you pump
the water out.
After certain time you may open the door if the water level in the
drum is low enough, otherwise you must fi st empty the water
(use additional program Pumping water out or Spin .
MA (models with the door opening by pressing the G knob
feature the function which enables you to open the door of
the appliance during power failure using special lever, located
adjacent to the
fi lter.
• Setting the time of day
- Press MENU (B) and QUICK knobs (D), and turn the program
selector (A) to the fi rst clockwise program. Display reads
CLOCK and =00:00 (hh:mm) in the right corner.
- Hours start fl ashing; push the SELECTION knob (C) to set the
time of day.
- Con fi rm setting by pushing the MENU knob (B).
- Now minutes start fl ashing; they are set the same way as
hours.
- Con fi rm setting by pushing the MENU knob (B).
- Return the program selector back to “0” position. Set time is
automatically saved.
•
Setting the Clean water sensor
In order for the Clean water sensor to start working
properly, it must be fi rst calibrated with water that the washing
machine is connected to. This is performed in the following
Special functions
(certain models only)
Special functions
(certain models only)
17