Gorenje VC 1800 WD 3CLEANER, Instruction Manual

Page: 25 / 46

25
Figure 29
In the case of greater clogging (after vacuuming
fluids or moist dirt), wash out the filter with a mild
cleaning solution under running water and allow to
dry before replacing it.
Figure 30
•
Put the motor protection filter onto the cone.
•
Screw the cap on tight.
•
Refit the motor housing. Connect the fluid hose
into the connector on the vacuum cleaner (see
Figure 6 ).
Replace damaged or torn filters. Never use the
vacuum cleaner without a motor protection
filter.
BLOWING FUNCTION
This function is used for blowing, instead of
vacuuming by the help of the outlet air pressure, by
the same accessories used in vacuuming operation
(flexible hose, extension tubes). For preparing the
appliance for blowing function:
−
Detach the main air outlet frame by pressing the
latch on it (fig. 31).
−
Remove the foam filter (I) as seen on figure 32.
WARNING
NEVER REMOVE THE FOAM FILTER (II) SHOWN
ON FIGURE 32.
−
Attach the wide end of the flexible hose to the
hole in the middle of the outlet opening (fig.33), if
necessary attach an extension tube to the other
end of flexible hose .
−
The appliance is now ready for blowing function.
Switch the appliance on (fig.8).
WARNING
Check all the pieces and filters regularly. Replace
damaged or torn filters immediately. The spare
filters are available from your dealer. When there is
a notable drop in the suction power, check if there is
a blockage in the air flowing path.
For storing the appliance, check if all the pieces,
drum and accessories is clean and dry.
GORENJE WISHES YOU A LOT OF
PLEASURE WHEN USING YOUR
APPLIANCE