7
Instructions for Use
Positioning and Installation
electric devices (hair dryer etc.), and never
scrape off the ice or frost layer with sharp
tools.
• For the sake of environment protection - be
careful not to damage the rear wall of the
appliance (the condenser unit or the tubes -
for example when moving the appliance) or
any part of the refrigerating system inside
the appliance. Do not use sharp object
for defrosting the appliance. Use only
enclosed tools or tools recommended by
the manufacturer.
• The refrigerating system of the appliance
is
fi
lled with refrigerant and oil, so when
the appliance is damaged, handle it with
care and dispose it of in compliance with
environmental protecting precautions.
• In the supply cord is damaged, it must be
replaced by the manufacturer or his service
agent or a quali
fi
ed person in order to avoid
hazard.
• The rating plate is inside the appliance or
outside on the rear wall.
Choosing the Right Place
Place the Pantry kitchen in a dry and regularly
Allowed ambient temperature depends on the
model (class) of the appliance and is stated on
the rating plate of the appliance.
Do not place the unit near heat-emitting
devices (e.g. cooker, radiator, water heater or
similar devices), and do not expose it to direct
sunlight.
Class
Ambient temperature
SN (sub-normal)
od + 10°C do + 32°C
N (normal)
od + 16°C do + 32°C
ST (sub-tropical)
od + 16°C do + 38°C
T (tropical)
od + 16°C do + 43°C
Placing
• Place the unit
fi
rmly on a solid base.
• On the front side of the appliance, there are
three adjustable feet; two of them are used
for leveling the refrigerator, while the third
is used for leveling the whole unit.
• For
fi
re protection, this pantry kitchen
complies with the Y class, which means
that other kitchen units can be located on
both sides of the unit; one of them should
be the same height as the unit, the other
can be higher.
• Warning! The appliance should not be
installed in a built-in element or cupboard.
Connection to Power Supply
Plug the cooktop and the refrigerator power lead
to the mains supply.
The power lead must be
fi
tted with earthing pin
(safety socket).
The standard nominal voltage and frequency are
indicated at rating plate(s) of the cooktop and the
fridge.
The connection to the mains supply and earthing
have to be made according to current standards
and regulations.
The refrigerator resists temporary voltage
tolerance between -6 and +6 %. If there is
no power supply cord provided in the pantry
kitchen, a special device for separation of all
poles from the mains supply must be included
when permanently installing the appliance, with a
minimum distance of 3 mm between the contacts
in the open position.
To replace a damaged power supply cord
a special device must be used therefore a
serviceman authorised by the producer must be
called.
Connecting the Water Outlet
Mount the sink to the water outlet according to
current regulations.
Leave the work to an expert who can at the same
time check whether the sink is watertight or not.
