EN 21
Removing and replacing the oven door
(depending on the model)
1. Open the oven door (up to end position).
2. Raise up and turn the flaps.
3. Slowly close the oven door, lift it slightly and pull it
out from the both hinges of the appliance.
Provide these steps in reverse order at
returning the door back. If the door does not open or
close properly, make sure, that the hinges are
correctly located on their hooks.
REMOVING AND INSERTING THE OVEN
DOOR GLASS PANE
(depending on the model)
Oven door glass pane can be cleaned from the inside,
but it has to be removed first. Remove the oven door
(see chapter "Removing and replacing the oven
door".
Slightly lift the supports on the left and right side of
the door (marking 1 on the support) and pull them
away from the glass pane (marking 2 on the support).
Hold the door glass pane by the lower edge; slightly lift
it so that it is no longer attached to the support; and
remove it.
To remove the third glass pane (only with some
models), lift and remove it. Also remove the rubber
seals on the glass pane.
To replace the glass pane, observe the reverse
order. The markings (semicircle) on the door and the
glass pane should overlap.
Removing and inserting the oven door glass pane
(depending on the model)
Screw out the screws on the door left and right sides
and pull out the upper lath. You can pull out the glass
pane of door now.
Provide these steps in reverse order at
returning the glass pane back.
