11
INSTALLATION INSTRUCTIONS
Exhaust hose installation in to the wall
Not applicable to the units without adaptor A, expansion plugs and wooden screws.
Water drainage
1. Prepare a hole in the wall. Install
the wall exhaust adaptor A onto
the wall (outside) by using 4
expansion plugs and wooden
screws, be sure to fix thoroughly.
2. Attach the exhaust hose to wall
exhaust adaptor A.
NOTE:
Cover the hole using the
adaptor cap when not in use.
The exhaust hose can be
compressed or extended moderately
according to the installation
requirement, but it is desirable to
keep the hose length to a minimum.
IMPORTANT:
DO NOT OVER
BENDTHE EXHAUST HOSE .
CAUTION: Make sure that there is
no obstacle around the air outlet of
the exhaust hose (in the range of
500mm) in order to the exhaust
system works properly.
Expansion plug
position
Adaptor A
Adaptor cap
•
During dehumidifying modes, remove the upper
drain plug from the back of the unit, install the drain
connector (5/8 universal female mender) with ¾
hose(locally purchased). For the models without
drain connector, just attach the drain hose to the
hole. Place the open end of the hose adaptor directly
over the drain area in your basement floor.
•
When the water level of the bottom tray reaches a
predetermined level, the unit beeps 8 times, the
digital display area shows ‘P1’. At this time the air
conditioning/dehumidification process will
immediately stop. However, the fan motor will
continue to operate (this is normal).Carefully move
the unit to a drain location, remove the bottom drain
plug and let the water drain away. Reinstall the
bottom drain plug and restart the machine until the
P1 symbol disappears. If the error repeats, call for
service.
NOTE: Be sure to reinstall the bottom drain plug
before using the unit.
•
Remove plug
