Action
Possible causes
Problem
Loosen the drainage hose where it
connects to the sink unit's water trap.
Check that no debris has fastened. Is
the cone-shaped part of the pipe cut to
an inner diameter of at least 14 mm?
Blocked drainage hose.
Water remains in the dishwasher.
Check that the hose is free from kinks
and sharp bends.
Kink in drainage hose.
Clean the coarse and fine filters.
The filters are blocked.
Clean the drainage pump. See the
section Care and cleaning.
Debris in the drainage pump.
Clean with washing-up brush and low
foaming cleaner.
Dirt around the seals and in corners.
Bad odour in dishwasher.
Run a programme with a higher
temperature about once a month.
Low temperature programmes have
been selected for a prolonged period.
Deactivate the Water tank setting. See
the chapter Settings.
The dishwasher has not been used for
a while.
Activate the Extra Dry option.
Drying power too low.
The dishes are not dry enough.
Fully load the dishwasher.
The dishwasher is not fully loaded.
Top up with rinse add or increase the
rinse aid dosage. See the sections
Before washing for the first time and
Settings.
Rinse aid needs topping up or dosage
is set too low.
Open the door a little once the
programme has finished.
Check that the baskets are correctly
positioned horizontally.
The baskets are not correctly
positioned.
Cannot close door.
Check that the dishes are not blocking
the baskets from sliding properly into
place.
Wait a moment then try again.
You have pressed the buttons too soon
after opening the door.
The buttons do not react when pressed.
Clean with a dry or slightly damp cloth.
The buttons are dirty.
Open the door. The buttons only react
to use when the door is open.
The door is closed.
13