Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is
fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time, let the water
run to make sure that the water is clear and free of impurities. If this precaution is not taken,
there is a risk that the water inlet can get blocked and damage the appliance.
The water supply to the appliance can also be connected to the house hot water line
(centralized system, heating system),as long as it does not exceed a temperature of 60 C.
In this case, the wash cycle tim e will be shortened by about 15 minutes and the wash
efficiency slightly reduced.
The connection must be made to the hot water line following the same procedures as those
for the connection to the cold water line.
Position the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent
cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to
facilitate proper installation.
Improper connection of the equipment-grounding conductor can result in a risk
of electric shock. Check with a qualified electrician or service representative if you
are in doubt whether the appliance is properly grounded. Do not modify the plug
provided with the appliance; If it is not fit for the outlet. Have a proper outlet installed
by a qualified electrician.
n
19
In order to avoid that there is more water staying in the inlet hose,
please close the hydrant after using.(Fo r the models : no safety inlet hose.)
Dishwasher must be level for proper dish rack operation and wash performance.
Place level on door and rack track inside the tub as shown to check that the
1
dishwasher is level.
2 When level the dishwasher, please pay attention not to let the dishwasher tip over.
If the sink is 1000 higher from the floor, the excess
water in hoses cannot be drained directly into the sink.
It will be necessary to drain excesswater from hoses
into a bowl or suitable container that is held outside
and lower than the sink.
Insert the drain hose into a drain pipe with a minimum diameter of 40 mm, or let it run into the sink, m aking sure to avoid bending
or crimping it. Use the special plastic support that comes with the appliance. The free end of the hose must be at a height
between 400 and 1000mm and must not be imm ersed in water.
φ
40mm
Drain hose hook
Dr ain pipe
Fro nt
A
B
C
Close the drain hose hook to the counter
Counter
Summary of Contents for GS62110BW
Page 1: ...GS62110BW...
