Gorenje GI64160, Operating Instructions Manual

Page: 27 / 32

• Make sure the area on which the
dishwasher is to be installed is firm.
Adjust the adjustable feet so that the
dishwasher is level.
• If the dishwasher is built-in the
surrounding furnishings must be
resistant to any condensation from the
dishwasher.
• Affix the protective film (packed in the
document bag) to the underside of the
worktop. The protective film is to protect
the worktop from moisture.
• Check that the machine is installed
such that the door opens freely,
otherwise door lock functionality may
be disrupted.
Drainage connection
See the separate installation instructions
for necessary information.
The drainage hose may be extended by
a maximum of 3 m (the total length of the
drainage hose must not exceed 4.5 m).
Any joins and connecting pipes must have
an internal diameter of at least 14 mm.
However, the drainage hose should ideally
be replaced with a new hose without joins.
No part of the drainage hose may be more
than 950 mm above the bottom of the
dishwasher. The hose must not be routed
directly to a floor drain or the like. In such
cases, the hose can act as a siphon and
empty the dishwasher.
The hose must always discharge at least
350 mm above the bottom of the machine.
Attach the drainage hose with a hose
clamp. Ensure that the drainage hose has
no kinks.
NOTE!
When the drainage hose is routed to a
connection nipple on the sink unit's water
trap, the hose must be attached at the
same height as the underside of the sink
unit (1), otherwise dishwater from the
sink may flow back into the dishwasher.
There are other connection alternatives
(2, 3). The water trap must be ventilated.
1 2 3
Connection to water supply
Use only the inlet hose supplied with the
dishwasher. Do not re-use old or other
spare hoses.
The supply pipe must be fitted with a
water tap (stopcock). The water tap must
be easily accessible, so that the water can
be shut off if the dishwasher has to be
moved.
Once the installation is complete, turn on
the water tap and allow the pressure to
settle for a while. Check that all
connections are watertight.
Connection to cold water supply
Connect the dishwasher to the cold water
supply if the building is heated using oil,
electricity or gas.
Connection to hot water supply
Connect the dishwasher to the hot water
supply (max. 70 °C) if the building is
heated using an energy-efficient means
such as district heating, solar power or
27