460401
Tools required: socket wrench No. 8, Phillips screwdriver, torx 25,
fl
at screwdriver
The procedure to change the direction of door opening should be carried out by at least two
persons.
1.
Remove the upper hinge cover (A) and the covering cap (G).
2.
Undo the upper hinge (B) and remove the door (C) from the lower hinge (D).
3.
Tilt the appliance backwards (make sure you do not press against the condenser unit on the
rear wall of the appliance as this may damage the cooling system), unscrew the lower hinge (D)
and the foot (E), and move them to the opposite side. Make sure the washer is installed like it
was before disassembly.
4.
Move the door hinges (F) to the opposite side and replace the door (C) back on the lower hinge (D).
5.
Use the screws to attach the upper hinge (B) on the opposite side.
6.
Replace the upper hinge cover (A) and the covering cap (G) on the opposite side.
7.
Replacing the handle (H): remove the handle covering caps, undo the screws, and remove
the handle. Remove the hole plugs on the opposite side of the door and attach the handle.
Replace the covering caps on the handle. Insert the new hole plugs supplied in the bag with the
instruction manual into the holes where the handle was initially attached.
Replacing the hinged handle:
- Push a small screwdriver into the handle
slot as indicated in Figure 1 and remove
the
cover.
- Remove the caps on the opposite side of
the
door.
- Undo the three screws, making sure not
to disassemble the handle.
- Rotate the handle by 180° as indicated in
Figure 3 and attach it to the opposite
side of the door.
- Replace the cover and the caps.
1
2
3
4
9
Changing the direction of door opening
Version I – controls in
the appliance interior
Summary of Contents for FN6192O
Page 1: ...EN Instruction manual Upright Freezer ...
Page 10: ...460401 10 ...
Page 20: ...FREEZER FS 600 en 09 15 ...